Specifications
Equipped With
GENERAL SPECIFICATIONS:
NEW APPROXIMATELY 1990
EQUIPPED WITH:
THREE STAGE SYSTEM CONSISTING OF THE FOLLOWING CYCLES:
WASH, RINSE, CURE
TYPE OF EQUIPMENT:
PHILLIPS MANUFACTURING COMPANY'S CROSSROD TYPE LIQUID-LIQUID-
VAPOR DEGREASERS ARE TWO CHAMBER LIQUID-LIQUID-VAPOR MACHINES
DESIGNED FOR USE WITH STANDARD CHLORINATED OR FLUORINATED
DEGREASING SOLVENTS. COOLING IS ACCOMPLISHED BY A SELF-CONTAINED
WATER CHILLING SYSTEM TO ELIMINATE AN EXTERNAL COOLING WATER
SUPPLY. OPTIONALLY, ULTRASONICS MAY BE INSTALLED IN THE RINSE
CHAMBER FOR MORE EFFECTIVE CLEANING OF STUBBORN SOILS.
USES:
THESE DEGREASERS MAY BE USED FOR CLEANING AND DEGREASING BATCHES
OF SMALL PARTS. LARGER PARTS MAY BE CLEANED UP TO THE LIMIT OF
THE WORK BASKET. ELECTRONIC ASSEMBLIES AND PRINTED CIRCUIT
BOARDS MAY BE EFFECTIVELY CLEANED OF DIRT, OILS AND SOLDER FLUX
USING THIS EQUIPMENT.
SOLVENT CYCLE:
SOLVENT IS HEATED IN THE BOIL CHAMBER BY A SET OF ELECTRIC
IMMERSION HEATERS. THE DENSE VAPOR WHICH IS GENERATED RISES
INSIDE THE TANK TO THE LEVEL OF THE PERIPHERAL COOLING COILS.
THE VAPOR CONDENSES ON THE COOLER COIL SURFACE AND THE DISTILLATE
DROPS INTO THE CONDENSATE TROUGH IMMEDIATELY BELOW. THE
DISTILLED SOLVENT IS PIPED TO A GRAVITY TYPE WATER SEPARATOR, OR
OPTIONALLY, TO A DESICCANT DRYER TO REMOVE ANY MOISTURE. THE
WATER-FREE SOLVENT IS PIPED TO THE DEGREASER RINSE CHAMBER WHICH
IN TURN, OVERFLOWS INTO THE BOIL CHAMBER, THUS COMPLETING THE
SOLVENT CYCLE.
POWERED CONVEYOR SYSTEM - 4' WIDE EQUIPPED WITH (10) 45" OD X 28"
H PARTS DRUMS AND YALE ELECTRIC OVERHEAD HOIST FOR LOADING
OVERALL SPACE REQUIRED 41'L X 27' W
THIS MACHINE IS IN LIKE NEW CONDITION ONLY HAS BEEN USED A FEW
MONTHS.
COST NEW WAS $135,000.00
