Specifications
Equipped With
#1015-B
GENERAL SPECIFICATIONS:
ARC WELD SYSTEM CONSISTING OF:
IRB L6AW/2 ROBOT
ADD'T DSDX 110 I/O BOARD
INSPECTION WINDOW
PULSESTAR 450 WELD POWER SUPPLY
GM WELD INTERFACE CABLE
TWECO PUSH/PULL WELD TORCH ASS'Y WITH WATER COOLER (BINZEL)
FLOOR MOUNT MAST UNIT
SPECIAL 500 LB. INDEX TABLE INFINITE POSITION WITH
TWO SERVO HEAD STOCK UNITS
OPERATOR PUSH BUTTON STATION
POSITIONER SPECIFICATIONS:
TWO INDEPENDANT SERVO-POSITIONING HEADSTOCK MOUNTED
FACING IN OPPOSITE DIRECTIONS ON A 180 DEGREE
TWO POSITION PNEUMATICALLY POWERED SWING TOP.
THE HEADSTOCK AXES ARE PROGRAMMED FROM THE ROBOT
TEACH PENDANT AND ARE COORDINATED WITH THE SIX
B AXIS ROBOT AXES.
EACH HEAD STOCK HAS A 16" DIAMETER FACEPLATE, CENTER,
BUSHING, AND FIXTURE MOUNTING HOLES.
THE POSITIONER IS EQUIPPED WITH A CENTER FLASH BARRIER
AND ANCHOR HOLES FOR ATTACHMENT TO THE FLOOR.
POSITIONER SPECIFICATIONS:
SWINIG TOP INDEX TIME: 75 SECONDS OR LESS
FACE PLATE ROTATION SPEED: 0-13 RPM BI-DIRECTIONAL
FACE PLATE OVER HUNG LOAD CAPACITY: 500 LB AT 6" OUT
FACE PLATE CONTINUOUS TORQUE CAPACITY: 3000 LB. - IN.
HEIGHT TO FACE PLATE CENTER: 45"
DISTANCE BETWEEN FACE PLATES: 70"
ELECTRONICS SPECIFICATIONS:
DRIVES FOR THE TWO HEADSTOCKS WILL BE HOUSED IN A
SEPARATE FREE-STANDING NEMA 12 ENCLOSURE, 16" X 32"
X 36" ON 24 LEGS. THE ENCLOSURE HAS ITS OWN 3 PHASE
ELECTRICAL DISCONNECT AND IS AIR-CONDITIONED. THE
CONTROL ELECTRONICS FOR THE HEADSTOCK AXES INSTALLED IN
THE 53 CONTROLLER.
PUSHBUTTON STATION:
A FREE STANDING PEDESTAL SUPPORTING THE CONTOL STATION
WITH CYCLE START/STOP AND E-STOP BUTTONS.
