Specifications
Equipped With
#98290-11
GENERAL SPECIFICATIONS:
SWING OVER BED 5.1"
CENTER HEIGHT 2.56"
DISTANCE BETWEEN CENTERS 12.2"
SWING OVER CROSS SLIDE 2.4"
TRAVEL OF CROSS SLIDE 1-9"
NET WEIGHT 121 LBS.
HEADSTOCK:
SPINDLE BORE .63"
SPINDLE TAPER MT2
TAILSTOCK:
CENTER SLEEVE DIAMETER 9"
TAILSTOCK TAPER MT1
SLEEVE STROKE 1.4"
FEED MOTORS:
STEP MOTOR (5DEGREE/STEP) 50 NCM
RAPID FEED 28"/MIN.
MAIN SPINDLE DRIVE
DC PERM. MAGNET MOTOR WITH SIX DRIVE RATIOS
SPEED RANGE 50-3200 RPM
MOTOR 2/3 HP
MOTOR OVERLOAD PROTECTION. AUTOMATIC POWER BALANCE PROVIDES
PRACTICALLY CONSTANT SPEED.
CONTROL UNIT
160 PROGRAM BLOCKS
FEED RANGE .04"-20" MIN.
RAPID TRAVERSE 28" MIN.
ALL TAPERS CAN BE CUT
RADIUS PROGRAMMING
ALARM INDICATES PROGRAMMING OR OPERATOR ERROR
FULL ON LINE EDITING FUNCTIONS
INCREMENTAL/ABSOLUTE PROGRAMMING
MAGNETIC MINI-CASSETTE TAPE READER
INCH AND METRIC THREADS
BLOCKS CAN BE DELETED AT LATER STAGE
TOOL OFFSETS
PROGRAM SYSTEM
N = BLOCK NUMBERS 00-159
G = PREPARATORY COMMAND
00 = RAPID TRAVERSE
01 = LONG. TURNING, FACING AND TAPER TURNING
O2 AND 03 = CIRCULAR INTERPOLATION (SPHERICAL TURNING)
20 = PROGRAMMED STOP
21 = NO OPERATION BLOCK
22 = PROGRAM END
23 = DNC INTERFACE
24 = RADIUS PROGRAMMING
26 = TOOL OFFSET
33 = THREAD CUTTING
64 = FEED MOTORS WITHOUT CURRENT SUPPLY
65 = MAGNETIC TAPE READER
66 = RS232 INTERFACE
78 = THREAD CUTTING CYCLE
84 = TURNING CYCLE
90 = ABSOLUTE DIMENSION/VALUE PROGRAMMING
91 = INCREMENTAL DIMENSIONS/VALUE PROGRAMMING
92 = PROGRAMMED OFFSET OF REFERENCE POINT
94 = FEED IN/MIN OR MM/MIN
95 = FEED/REV.
X AND Z = PROGRAMMED LONG. AND CROSS MOVEMENTS
F = FEED RATE
EQUIPPED WITH:
VIDEO MONITOR
3" 3 JAW CHUCK
3-1/2" 4 JAW CHUCK
COLLET CLOSER
(1) MOTORIZED TURRET AND TOOLING
