Specifications
Equipped With
GENERAL SPECIFICATIONS:
THE POWDER SYSTEM CONSISTS OF A THERMA-TRONIX 7-8 STAGE WASHER, A
NORDSON AUTOMATIC POWDER BOOTH, AND A THERMA-TRONIX GAS FIRED
OVEN AND A THERMA-TRONIX GAS FIRED OVEN WITH AN ELECTRIC
INFRARED PRECURE OVEN. THIS SYSTEM IS EQUIPPED WITH AN OVERHEAD
CONVEYOR LINKING ALL THREE PHASES.
THE THERMA-TRONIX 7 STAGE WASHER CAN RUN EITHER IRON PHOSPHATE OR
ZINC PHOSPHATE. STAGE 1 & 2 ARE HEATED BY GAS AND USED FOR
CLEANING. STAGE 3 & 4 ARE RINSE TANKS. STAGE 5 IS STAINLESS
STEEL AND IS USED FOR THE PHOSPHATE TREATMENT. IT IS HEATED BY A
HEAT EXCHANGER FROM TANK 2. TANK 5 IS KEPT CLEAR BY THE USE OF
AN EXTERNAL CLARIFIER. STAGE 6 IS A RINSE CYCLE. STAGE 7 IS FOR
A SEAL RINSE. A SOFT WATER HALLO ENDS THE PROCESS. PARTS ARE
DRIED FOR ABOUT 6 MINUTES. THERE ARE AN EXTRA SET OF NEW NOZZLES
AVAILABLE.
THE NORDSON POWDER PAINT SYSTEM IS IN AN AIR CONDITIONED CLEAN
ROOM. IT HAS 8 AUTOMATIC AND 3 MANUAL VERSA II GUNS. TWO
MODULES EACH EQUIPPED WITH AN AZO SEPARATOR AND FLUIDIZER MAKE
QUICK COLOR CHANGES. THERE IS BOTH A BOX AND DRUM TRANSFER PUMP.
THE COMPRESSED AIR SYSTEM HAS GRAHAM-WHITE WATER/OIL SEPARATOR
AND AIR CARBON MONOXIDE MONITOR. THERE ARE MANY REPAIR PARTS
AVAILABLE. THE ENTIRE UNIT IS MOUNTED ON CASTERS.
THE THERMA-TRONIX CURING PROCESS CONSISTS OF 2 STAGES. THE
POWDER IS "JELLED" BY THE ELECTRIC INFRAREDS FOR 3 MINUTES AND
CURED FOR 20 MINUTES IN THE GAS FIRED OVEN.
THE SYSTEM WAS INSTALLED NEW IN 1996 AT A COST OF $750,000.00.
IT HAS NOT BEEN USED SINCE 12/99. IT IS IN EXCELLENT CONDITION.
* PHOTOS ARE AVAILABLE UPON REQUEST.
DIMENSIONS: THERMA-TRONIX WASHER: 102 FT. L x 8FT. W WITH A
2.5 FT. x 5 FT OPENING.
NORDSON POWDER BOOTH: 22FT. L x 8 FT. W WITH A
2.5 FT x 5 FT. OPENING.
THERMA-TRONIX DUAL OVEN: 62 FT. L x 8 FT W WITH A
4FT x 5 FT. OPENING.
